*STYLES & COLORS MAY VARY*
The standard GameCube controller provides haptic feedback by way of a built-in rumble motor rather than using an external Rumble Pak add-on like the Nintendo 64 controller. Also unlike its predecessor, this controller does not feature any expansion capabilities.
The primary analog stick is on the left, with the D-pad below it. The four face buttons are on the right of the controller (a large green "A" button in the center, a smaller red "B" button to its bottom left and two kidney-shaped buttons; "X" to the right and a "Y" to the top) with a yellow "C" stick below those. A Start/Pause button is located in the middle of the controller. On the "shoulders" of the controller there are two analog triggers marked "L" and "R," as well as one digital button marked "Z" which sits above the "R" trigger. The "L" and "R" triggers feature both analog and digital capabilities. Each of these behaves as a typical analog trigger until fully depressed, at which point the button "clicks" to register an additional digital signal. This method effectively serves to provide two functions per button without actually adding two separate physical buttons.